Supported by the GlobalNOC at Indiana University

Hybrid Mode Configuration

Hybrid mode is configured on each interface.  Specifically you must specify the vlan-range to allow in hybrid mode

xe-7/0/0 {
    flexible-vlan-tagging;
    encapsulation flexible-ethernet-services;
    unit 0 {
        family bridge {
            interface-mode trunk;
            vlan-id-list 100-4094;
        }
    }
}

then once you have all of the sub interfaces configured you must add them to the openflow configuration Here is an example

protocols {
    lldp {
        enable;
    }
    openflow {
        switch al2s {
            default-action {
                drop;
            }
            emergency-mode;
            interfaces {
                xe-7/0/0.0;
                xe-7/0/1.0;
                xe-7/0/2.0;
                et-5/0/0.0;
            }
            controller {
                protocol {
                    tcp {
                        port 6633;
                    }
                }
                role equal;
                address 140.182.45.44;
            }
        }
    }
}
routing-instances {
    al2s_of_switch {
        instance-type virtual-switch;
        interface et-5/0/0.0;
        interface xe-7/0/0.0;
        interface xe-7/0/1.0;
        interface xe-7/0/2.0;
        bridge-domains {
            al2s {
                vlan-id-list 100-4094;
            }
        }
    }
}

Your request has been completed.